I recently held a virtual event where we all created a simple, Christmas in July card. I had originally found this design on Pinterest, and just changed up the designer series paper and embellishments. This is such a simple but practical card that can be mass produced for Christmas or any occasion really.
Supply List:
Cardstock:
Cherry Cobbler 119685 cut at 5 ½”x 8 ½” scored at 4 ¼”; scrap for sentiment
Basic
White 159276 cut at 4” x 5 ¼”, scrap for punch
Tidingsof Christmas dsp 155718 cut at 3 ¾” x 5”
Punch:
Everyday Label 144668
Ink:
Memento 132708
Stamp
Sets: Banner Year 158239
Accessories:
Silver & Epoxy Essentials 155567, Simply Elegant Trim 155766 4”
Adhesive
152813, dimensionals 104430
Paper
Trimmer 152392
Step- By- Step Instructions:
Stamping:
Using
the scrap of basic white, stamp Be Merry from the Banner Year stamp set with Memento ink and
punch out using the Everyday Label punch.
If you would like to add a sentiment for the insert, you can do that
now.
Taking
the piece of designer series paper, use your trimmer and cut from corner to
corner, diagonally. You should now have
four pieces, two of each size.
Now let’s assemble our
card:
Adhere the white matte
to the Cherry Cobbler cardbase. You can
also add the basic white insert. Start glueing
the dsp down, choosing which pieces you want flipped over. There should be two of each design showing. I left a white border showing all around the
triangles. Stick the punched sentiment
to the punched cherry cobbler using stampin seal. Then add dimensionals to the bottom. Run your trim in a criss cross manner in the
center of the triangles-I make sure it is held down by the dimensionals from
the punched sentiment. Add your epoxy essentials on your finished card.
Comments
Post a Comment